Podcast and audiobook platforms measure different things. Apple Podcasts asks for about -16 dB LKFS with a true peak no higher than -1 dB FS, and Spotify's podcast specification sets no level target at all.[1][2] Audiobook platforms measure RMS and noise floor instead, ACX adds a peak ceiling, and both set room tone and per-file length rules.[3][4]
So a file mastered for one world is not automatically right for the other, in either direction. A podcast episode can be perfectly in spec for Apple and still miss the audiobook RMS window, and an audiobook master can sit below the level Apple recommends. This guide lays out what each platform actually publishes, side by side, and explains why the numbers do not translate. One thing to say plainly before we start: chapterpass masters audiobooks. It does not master podcasts.
What does Spotify require for a podcast episode?
Very little on audio level, and that is the surprise. Spotify's Podcast Delivery Specification is the document Spotify for Creators points podcasters to for "file format and encoding requirements".[5] Its audio section, in full, reads: "We recommend either high bitrate (128kbps+) MP3 (only MP3 is supported for passthrough) or MP4 with AAC-LC. A maximum duration of 12 hours (roughly 2GB @ 320 Kbps) is recommended/supported."[1]
That is the whole of it. There is no loudness target, no peak ceiling and no noise floor rule anywhere in the specification.[1]
If you upload directly through Spotify for Creators rather than delivering a feed, the rules are just as light. Spotify supports MP3, M4A and WAV files, says files "will need to be either in mono or stereo", and states that it has no file size limit, though larger files take longer to process.[6] The upload guide gives no bitrate or loudness guidance either.[6]
What does Apple Podcasts ask for?
Apple Podcasts does publish a loudness target, and it is written in LKFS. Apple recommends preconditioning audio so "the overall loudness remains around -16 dB LKFS, with a +/- 1 dB tolerance", and so the true-peak value does not exceed -1 dB FS.[2] Both values are calculated according to ITU-R BS.1770-5, and Apple asks for this preconditioning to happen before encoding, because audio compression typically does not modify loudness and can clip the signal.[2]
For subscriber audio, Apple Podcasts Connect accepts WAV, FLAC or MP3, while RSS feeds take MP3 or AAC, and Apple strongly recommends AAC for feeds.[2] For feed audio at 44.1 or 48 kHz, Apple recommends 64 to 128 kbps for mono and 128 to 256 kbps for stereo.[2] There is also a channel rule worth knowing: single-channel audio is not accepted for WAV or FLAC files, while MP3 accepts mono or stereo.[2]
What Apple does not publish is just as telling. There is no noise floor figure, no room tone rule and no per-file length cap on the audio requirements page.[2]
What do audiobook platforms ask for instead?
Audiobook platforms describe the file in RMS, peak and noise floor, and they care about the silence at each end.
ACX requires every file to fall "between the specific volume range of -23dB and -18dB RMS", with peak values no higher than -3 dB and a noise floor no higher than -60 dB RMS.[3] Each file must be a 192 kbps or higher CBR, 44.1 kHz MP3, no longer than 120 minutes, and room tone at the head and tail must not exceed 5 seconds, with 1 to 5 seconds recommended.[3] The full ACX audio requirements guide walks through each of these in depth.
Spotify for Authors, the audiobook side of Spotify, is a different document from the podcast specification. Its recommended qualities are RMS between -24 dB and -14 dB, a noise floor under -60 dB, head time of 0.5 to 1 second and a tail of 1 to 5 seconds.[4] MP3 is preferred at 192 kbps or higher, CBR preferred, 44.1 kHz and 16 bit, with WAV and FLAC also accepted, and each chapter must be a standalone file no longer than 120 minutes.[4] It sets no peak rule. The Spotify for Authors audio requirements guide covers it in full.
How do the four sets of requirements compare?
| Requirement | Spotify Podcasts[1][6] | Apple Podcasts[2] | ACX[3] | Spotify for Authors[4] |
|---|---|---|---|---|
| Loudness measure | not published | LKFS (ITU-R BS.1770-5) | RMS | RMS |
| Loudness target | not published | about -16 dB LKFS, ±1 dB | -23 to -18 dB RMS | -24 to -14 dB RMS (recommended) |
| Peak rule | not published | true peak not above -1 dB FS | no higher than -3 dB | not published |
| Noise floor | not published | not published | no higher than -60 dB RMS | under -60 dB (recommended) |
| Room tone | not published | not published | 1 to 5 s recommended, 5 s maximum | head 0.5 to 1 s, tail 1 to 5 s |
| Per-file length | 12 hours recommended/supported | not published | 120 minutes | 120 minutes |
| Format and bitrate | MP3 128 kbps+ or MP4 AAC-LC (feed); MP3, M4A or WAV (upload) | Subscriber audio: WAV, FLAC, MP3; feeds: MP3 or AAC | MP3 only, 192 kbps+ CBR, 44.1 kHz | MP3 192 kbps+ (CBR preferred), 44.1 kHz; WAV 44.1 kHz 16 bit; FLAC |
Read the rows from top to bottom and the split is obvious. The podcast columns are about format and, in Apple's case, a loudness and true-peak target. The audiobook columns add the noise floor, the silence at each end and a much shorter cap on file length. The noise floor and the silence at each end appear in neither podcast column.
Can you use a podcast export for an audiobook?
Not without measuring it, and usually not without remastering it. There are three reasons, and each one is in the published specs.
The loudness numbers are on different scales. Apple's -16 dB LKFS is measured with ITU-R BS.1770, which applies a "K" frequency weighting and then gates the signal in 400 ms blocks, discarding blocks below -70 LKFS and blocks more than 10 dB below the level measured after that first gate.[7] In plain terms, an LKFS reading leans on how the ear weights frequencies and leaves very quiet 400 ms blocks, such as longer pauses between phrases, out of the average. An RMS reading, the measure ACX and Spotify for Authors use, is a different calculation.[3][4] So a file sitting exactly on Apple's target does not guarantee where its RMS lands. It might land inside -23 to -18 dB RMS, or it might not. The only way to know is to read the RMS directly. Our guide to audiobook loudness in RMS and dBFS explains what that reading means.
The peak ceiling is lower for audiobooks. Apple allows a true peak up to -1 dB FS.[2] ACX wants peaks below -3 dB.[3] A podcast master peaking at -2 dB FS, for example, is in spec for Apple and above ACX's -3 dB limit.
Nobody on the podcast side looks at the noise floor. Neither Spotify's podcast specification nor Apple's audio requirements publishes a noise floor figure.[1][2] ACX and Spotify for Authors both set it at -60 dB.[3][4] A podcast that sounds clean in the car can still carry room hiss in the gaps that fails an audiobook review, and raising the level to reach a loudness target raises that hiss with it. The audiobook noise floor guide explains how the noise floor is measured and what moves it.
Format and structure add two more steps. ACX takes MP3 only at 192 kbps or higher CBR, so an AAC podcast file or a 128 kbps MP3 needs re-exporting.[3] And both audiobook platforms want each file at 120 minutes or less, with room tone at the head and tail, where a podcast episode can run up to 12 hours on Spotify with no padding rule at all.[1][3][4]
And the other way round?
The reverse trip has its own catch. An audiobook master inside the ACX window is not guaranteed to land near Apple's -16 dB LKFS, for the same reason: the two measures are different calculations.[2][7] Spotify's podcast specification has no level target, so there is no loudness figure for an audiobook file to miss there, but that is not the same as sitting where Apple recommends.[1] If you publish the same recording as a podcast, master that version to the podcast platform's own target.
Common Questions
Does Spotify have a loudness requirement for podcasts?
What loudness does Apple Podcasts recommend?
Around -16 dB LKFS with a ±1 dB tolerance, and a true peak no higher than -1 dB FS, both measured according to ITU-R BS.1770-5.[2]
Is -16 LKFS the same as ACX's RMS range?
Do Spotify Podcasts and Spotify for Authors use the same audio rules?
Can I upload my podcast episode to ACX as an audiobook chapter?
Only if it meets the ACX spec: RMS between -23 and -18 dB, peaks no higher than -3 dB, noise floor no higher than -60 dB RMS, room tone at the head and tail, a 192 kbps or higher CBR 44.1 kHz MP3, and no more than 120 minutes per file.[3] Most podcast exports need remastering and re-exporting to get there.
Does chapterpass master podcasts?
No. chapterpass masters audiobook files to audiobook platform requirements such as ACX. It does not master podcasts to a podcast platform's loudness target.
Ready to submit?
Run the free ACX check to see exactly where your file stands, or let chapterpass master it to spec in one step.